Copyright © www.batteriestransport.org 62 2.1.2.2 LEAD-ACID BATTERY ELECTROLYTE - LIMITED QUANTITIES Applies to: Electrolyte of lead-acid batteries transported in limited quantities UN No., Proper Shipping Name UN 2796, BATTERY FLUID, ACID Class 8 n/a Packing Group II Hazard Label • Labels must be in the form of a square set at an angle of 45° (diamond-shaped) with minimum dimensions of 100 mm by 100 mm; except for air transport mode, labels dimensions may be reduced in the case of packages of such dimensions that they can only bear smaller labels. • They must have a line 5 mm inside the edge and running parallel with it. General Requirements • metal packagings must be corrosion resistant or with protection against corrosion • transport permitted in glass inner packagings only if the substance is free from hydrofluoric acid. Transport mode ADR IMDG IATA Passenger Aircraft Cargo Packing instructions PI Y840 Battery fluid shall be packed only in inner packagings placed in suitable outer packagings; single packagings are not permetted. • Capability of the package to pass a drop test of 1.2 m; • To pass a 24 hour stacking test; • Inner packagings for liquids must be capable of passing a pressure differential test (5.0.2.9- IATA); • the gross weight of the completed package must not exceed 30 kg Combination Packagings Inner: Non approved inner packagings with maximum capacity of 1 litre Glass, porcelain or stoneware inner packagings shall be enclosed in a compatible and rigid intermediate packaging. Outer: Non Approved suitable outer packagings . Total gross mass of the package shall not exceed 30 kg. Shrink-wrapped or stretch-wrapped trays meeting the conditions of 4.1.1.1, 4.1.1.2 and 4.1.1.4 to 4.1.1.8 are acceptable as outer packagings for battery fluid Total gross mass of the package shall not exceed 20 kg. Combination Packagings Inner: Non approved inner packagings made of: Glass - Plastic - Metal et quantity per inner packaging: 0.1 litre Outer: Non Approved outer packagings, having the capability to pass a drop test of 1.2 m, of the type: Drums (1A, 1B, 1N, 1H, 1D, 1G) Jerricans (3A, 3B, 3H). Boxes (4A, 4B, 4N, 4C1, 4C2, 4D, 4F, 4G, 4H1, 4H2, 4N) Total net quantity per package: 0.5 litre Weight limit see above see above see above see above Tunnel code - - - - Transport cat. - - - - Exemptions - - - - Marks must be in the form of a square set at an angle of 45° (diamond-shaped) with minimum dimensions of 100 mm by 100 mm; If the size of the package so requires, the minimum outer dimensions may be reduced to be not less than 50 mm x 50 mm Marking and Labelling of Packages Full Name ad Address of the shipper and the consignee Net Quantity (l) The words “THIS SIDE UP” or “THIS END UP” may also be displayed on the top of the package. Minimum dimensions: 74 × 105 mm Overpack OVERPACK + same labels as above OVERPACK + same labels as above OVERPACK + same labels as above OVERPACK + same labels as above Documents - MDGF the words "limited quantity" or "LTD QTY" shall be included. Shipper’s declaration
RkJQdWJsaXNoZXIy MjQwNg==